Last time we saw the river modules, they were bare white plastic with clay banks. I’m happy to report that progress has been made!

Nothing fancy, just a coat of black paint mixed with some white glue, then sand shaken over while everything was still wet. I’ll put another coat of paint and glue over the sand to fully secure it, then get on with the rest.

As seen in the photo above, the bridge is also fully painted. Over the black primer (mixed, as usual, with white glue) I blobbed two different green shades and some rust brown, then started drybrushing with a dark grey, a bit of tan, then lighter grey and finally just a bit of pure white on the edges and upper surfaces.

I’ll do the river banks alongside the bridge next, then paint and sand so all ten river segments are at the same stage, then it’s off to doing water effects, probably with epoxy resin.